No hazard steps:
Go into chamber, button to unbolt is near the door.
Maximise the injectors in the chamber.
maximise Cold loop pump in the (north western/aft port/upper left) corner
Use the fuel compressor to create two deuterium fuel rods
place one of the rods each into a fuel injectors at the chamber
Minimal Atmospheric hazard:
Pump two canisters of Phoron into the cold loop
Pump two canisters of N2O into the hot loop, dont use Phoron here!
Radiation Hazard:
maximise the engine SMES(the one on the aft/left/west) in the smes room
set the field strength in on the rust controll console
start injection with the fuel injectors
start the gyrotrons
set the gyrotrons to delay 1
set the gyrotrons to power 1
Engine set!
max input out put on the Main SMES in the SMES room